Wednesday 28 July 2010

Return Fuel line

I have for sometime been thinking that I may fit fuel injection in the future. So to make this as easy as possible I have decided to run a return fuel line in now, whilst I can easily get to hte chassis. Instead of another hard line Ive used Aeroquip push on hose as its more flexible and easier to route, it does however have a much bigger OD.

You can see from the previous post that it was roughly routed in when the prop went in, now its time to fix it.

To mount the hose I used clips, longer bolts and some section of 8mm tube. Job done.

Oh and Ive fitted the hard line adapter as well, so much easier with the right one! (engine bay end was a Veraflare not designed for metric pipe)

Propshaft

Somewhat unexpectedly a box was delivered last week containing my propshaft. I thought this was going to be one of the bits to be collected on my planned trip up to GD, more on that later.

So with it here it would be rude not to fit it! Now Ive heard all sorts of stories about it being a nightmare job due to the space restrictions and chassis tubes, in all honesty I didnt find it too bad. Now that may be because Im not using a tremec box. Just removed the brake union and jiggled it around till it went in!



Ive not tightened it up yet as it may have to come out again for the fitting of the speedo pulse ring, more on that later!

Saturday 24 July 2010

Coil Bracket

Yet another little job to be knocked off the list. I didnt want to mount the coil to the body of the car and the supplied bracket did not readily fit any of the mounting locations available on the engine. Now I have seen these things secured by just one bolt, but I didnt like that so I took a template from the front of the left hand cylinder head and designed a bracket.



Cleaned and sprayed with clear engine enamel it looks good, the coil is now securely held in place.

Friday 23 July 2010

Oil Pressure switch

Whilst sorting out the oil plumbing I had originally intended to mount the oil pressure switch, for the idiot light, in one of the oil lines. It then occurred to me that I could save a few quid and mount it into the block, where it would normally be mounted!

So I returned the expensive fancy adapter for a refund and exchanged it for a much cheaper threaded fitting.

One small problem though, I could not tighten it in with the fuel pump in place, so guess what, I had to take the pump out. Luckily I had a spare gasket and was able to refit the pump the same day!


Thats another job sorted and a few quid saved.